New bodyshell, same incredible design from the most successful E4 series. If you are looking for the easiest way to be an RC drifter. The E4D series is the way, the best ready to run drifting cars with the least maintenance and lots of upgrade possibilities.Plug in and feel it right now!

Drive ratio：Front 2.059 / Rear 1.944
 Length：374mm
Lightweight Pulley 
Width：186~193mm adjustable
Caster block：6 degree 
1/10 EP Sedan(Factory Assembled) 
Wheelbase：256~260mm 
Pre-painted body included.
Weight：1480g 
Specifications are subject to change without notice.

H.A.R.D. X3 18 turn motor

The H.A.R.D. 18 turn motor is incredibly powerful and is much faster than other kit motors. The internal cooling fins not only increase the performance but also the durability. And the best thing of all… it is completely maintenance free!

• Voltage Range：4.8V-12V
• Size：540 (54mm in diameter)
• Turns：18
• No-Load RPM：25500 RPM @ 7.2V
• Started Torque：2.99kg-cm @ 7.2V
• No-Load Current：2.8A @ 7.2V

H.A.R.D 2.4GHz Radio System

The radio and receiver are guaranteed to be of the highest quality available. From its lightweight design to its ergonomically designed figure, the H.A.R.D. Radio System is a perfect match for the E4D, and you can rely on it for years.

H.A.R.D. JR Dual Mode ESC

Two setup modes:

1) Gentle Mode： Yellow Indication Light On (50% output)
2) Fierce Mode：  Red Indication Light On (100% output)

• Motor Limit：19+ turns
• Heat Overload：85-90°
• Low Battery Alarm：4.5v or less
• Drive Frequency：1 kHz
• BEC：5.0V/1A
• Length：36mm
• Width：36mm
• Height：27.5mm
• Weight：47.3g (including wires)

New Shock Body

These new shocks have been re-designed to better suit the performance of the E4D, and as a result, the shocks are now smoother, stronger, and hassle free to build.
 
Front and Rear Universal Joints
 

 The universals in the E4D replace the standard dog-bone drive shaft which means better transmission efficiency and less maintenance, and no more loosen joints or lost dog-bones! 
 
 Flying Wing Suspension Arms

 Exclusive to TEAM MAGIC's latext vehicles are Flying wing suspension arms. These solid, flat and narrow suspension arms are designed to reduce maintenance time and aerodynamically improve airflow over the car. The new linkage provides mounting points for a newly designed rear sway bar and also increases the caster adjustability from 4mm to 6mm. The new arms are also lighter and stronger than the G4.

3 Belts Transmission

The 3 belt, fully ball raced transmission system sets the E4D apart from the rest. This unique design ensures the power can be delivered to four wheels at maximum efficiency thanks for high quality universal joints and low friction belts all made by TEAM MAGIC.

The 3 belt transmission offers tremendous benefits over the traditional 2 belt design which means the battery can now be placed closer to the center line of the car, giving the car better lateral weight distribution and minimum weight transfer. In addition to this, the motor is placed right behind the batter, which reduces the inertial effect from the motor, in other words, better dynamic performance.

All Metal Bearings

The E4D is equipped with 18 metal bearings for increasing transmission efficiency and durability. Each bearing is precisely sealed to reduce the chances of dirt entering the ball-raced area and damaging other components.

7.2V電池 充電器 須另購 $650元