Futaba S9153 TOC大型機用數位伺服機Digital Aileron/Elevator Servo

This is the Futaba S9153 Digital Aileron/Elevator Servo.
                 Comes with "J" Connector Pre-Installed.

FEATURES: Heavy duty wiring handles higher current loads
          Metal center casing which helps to dissipate heat and is designed to
            be water and dust resistant
          Dual ball bearing gear train
          Coreless motor
          High torque
          One year warranty
 

INCLUDES: One Futaba S9153 Digital Aileron/Elevator Servo
          Two rectangular grommets
          Four brass bushings
          Four 3mm x 15mm self-tapping phillips head mounting screws
          One 1.2" (30mm) diameter round horn
          One 3.5" (88mm) diameter star shaped six point horn
          One 3.9" (98mm) diameter four point horn
 

SPECS:    Speed:  .19 sec/60° @ 4.8V, .15 sec/60° @ 6V
          Torque: 167 oz-in @ 4.8V, 208 oz-in @ 6V (15 kg-cm)
          Weight: 3oz (85g)
          Length: 1.91" (48.6mm) case only
          Length: 2.54" (64.6mm) including mounting tabs
          Width:  0.99" (25.2mm)
          Height: 1.56" (39.7mm)
          Distance between mounting hole centers same side: 0.55" (14mm)
          Distance between mounting hole centers opposite side: 2.35" (59.6mm)
 

COMMENTS: S9153 Digital Servo Precautions,
          -It is best to avoid long leads and Y-harnesses especially with
           standard grade wires. If problems are encountered, consider using
           heavy duty wire such as Futaba's Heavy Duty Series or Hobbico's
           Pro Series,minimizing lead lengths, and/or removing Y-harnesses.
           -Current Drain: Futaba S9153 Servo is Specially Designed for High-
            Torque and High-Speed, Therefore Very High Current Drain Is
            Normal At Startup. For Ultimate Performance When Using This Servo
            Please Review The Following Points.
            (1) When Using Systems With the Battery Fail Safe Function it Has
              a Higher Cut-Off Voltage Setting Which Will Cause Shorter
              Operation Time.
            (2) When Installing the Servo Please Check Pushrod Linkage To Make
              Sure There Is No Binding in Order To Prevent Excessive Power
              Consumption and Decrease the Life of the Motor and Battery.
         This digital servo cannot be used with the following * AM *
               transmitters as the servo neutral signal is: 1310us).
        CONQUEST AM, FG Series (T4FG, T5FGK,T6FG, T6FGK, T7FGK), New Terra-
              top, T3EGX, T3PGE, T2NL, T2LGX, T2FR, T2PK series.